Copper pipe compression fittings installation

In hydraulic based installations, the system may be tested to 1. If higher test pressures are required, then please contact us for further advice. Flowflex reserve the right to alter the product ranges and specifications associated with its products without prior notice. Warranty only valid when compression fittings are used with Flowflex olives supplied with the fitting. Materials Copper Pipe Compression Fitting. Cut Your Pipe to Size Cut your pipe cleanly across the tube diameter.

It is important your pipe accurately. Failure to do so could impact on the quality of your jointing. If your cut is not flat, or your pipe is too short, the pipe may not hit the pipe stop compromising the joint integrity. Too long and you may introduce strain into the whole system. For Carbon, Stainless Steel and Chrome Plated Pipe, ensure no flats or score marks are visible on the outside surface of the tube. The weld bead should also not be visible.

Clean The Socket of the Pipe Using your deburring tool, make sure the inside of the pipe is smooth and will not interfere with the flow. In the case that flow local to the joint is affected, erosion and corrosion may occur and also vibrations.

Clean The Outside of the Pipe Clean the outside of the pipe, making sure that there is no pipe residue, dirt or grit is present near the joint. Assembly the Fitting Around the Tube Remove the compression nut and compression olive, then put the nut on the tube, followed by the olive.

Place one crescent wrench on the union. Once snug, tighten about one more half turn. Compression fittings are more reliable than threaded fittings. They are easier and faster to install than soldering. And they are safer because no torch is needed.

However, compression fittings can be prone to issues from vibration and repeated bending. In a DYI situation, the most common cause is over-tightening. Follow the instructions above for how far you can tighten. Compression fittings are a great solution for do-it-yourselfers who want a safe way to join or connect their copper pipes without a torch.

Although not without their potential issues, they are commonly used to make watertight connections quickly and easily. We can help you repair, remove, or install any type of pipes and fittings, including compression fittings and other solutions. We will also immediately respond to any of your emergency plumbing , drain cleaning and drain clearing, or water damage problems.

And we have specialists who excavate, repair, and replace broken sewer lines. Just send us a message or call us at Skip to content. How to Make a Compression Joint 1.

Shut Off the Water 2. Position the Parts 3. If the Tubing Kinks 4. Position the Parts and Join Them 3. Compression fittings are user-friendly, easy to install and have many purposes. Also, compression fittings can be used on leaky pipes such as broken water lines in an emergency situation. Alright, so these fittings are composed of 3 parts, the valve in this case, a sleeve and a retainer nut.

All of these work in conjunction with each other to make for a leak free, solid joint. So the first thing to do is to ensure that you pipe is free of any kinks, debris or just plain old dirt, so get yourself a clean paper towel or rag and clean it off as best as you could. Make sure to wipe off any excess flux or it will eat up your pipe.